MacDon M155 Unloading And Assembly Instructions page 263

4. Press right arrow (B) to select YES. Press SELECT (C).
• TO CALIBRATE SELECT will appear on the upper line.
5. Press left arrow (A) or right arrow (B) until HEADER FLOAT
appears on the lower line. Press SELECT (C).
• CALIBRATING FLOAT will appear on the upper line.
• PRESS FLOAT + TO START will appear on the lower line.
6. Press and hold FLOAT + button (A) on the CDM.
• CALIBRATING FLOAT will appear on the upper line.
• FLOAT ( + ) HOLD will appear on the lower line.
NOTE:
The word HOLD will flash during calibration. FLOAT ( + )
DONE will appear on the lower line once calibration is
complete.
7. Release FLOAT + button (A).
• CALIBRATING FLOAT will appear on the upper line.
• FLOAT ( – ) HOLD will appear on the lower line.
8. Press and hold FLOAT – button (A) on the CDM.
• CALIBRATING FLOAT will appear on the upper line.
• FLOAT ( – ) HOLD will appear on the lower line.
NOTE:
The word HOLD will flash during calibration. HDR FLOAT
COMPLETE will appear on the lower line once calibration is
complete.
9. Release FLOAT – button (A).
• TO CALIBRATE SELECT will appear on the upper line.
• HEADER FLOAT will appear on the lower line.
10. Press the right arrow to select the next header sensor calibration or select STOP & EXIT. Press SELECT.
11. Press PROGRAM to exit programming mode.
262320
CAB DISPLAY MODULE
A
Figure 7.93: Header Float Display
Figure 7.94: Positive Header Float Display
Figure 7.95: Negative Header Float Display
247
CALIBRATING FLOAT
CXXX
MXXX
PRESS FLOAT + TO START
CALIBRATING FLOAT
CXXX
MXXX
FLOAT ( + ) HOLD
CALIBRATING FLOAT
CXXX
MXXX FLOAT ( - ) HOLD
C
B
A
A
Revision A