MacDon M155 Unloading And Assembly Instructions page 257

6. Press left arrow (B) or right arrow (C) to cycle between
control switch lockouts. The displayed control switches are
as follows:
• HEADER TILT
• HEADER FLOAT
• REEL FORE/AFT
• DRAPER SPEED
• AUGER SPEED
• KNIFE SPEED
• DISK SPEED
• REEL SPEED
NOTE:
Not all control lock options apply to every type of header.
7. Press SELECT (D).
• EXIT VIEW LOCKOUTS? will appear on the upper line.
• NO/YES will appear on the lower line.
8. Press right (C) to select YES.
9. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
262320
CAB DISPLAY MODULE
A
B
Figure 7.81: Control Locks
A
B
Figure 7.82: Control Locks
241
DRAPER SPEED
CXXX
MXXX
575.1 HRS ENABLED
DRAPER SPEED
CXXX
MXXX
575.1 HRS ENABLED
D
C
D
C
Revision A