Enabling Or Disabling Header Sensors - MacDon M155 Unloading And Assembly Instructions

7. Press right arrow (A) to select YES. Press SELECT (C).
• The most recent error code will appear.
8. Press right arrow (A) or left arrow (B) to cycle through the
last ten recorded windrower error codes until EXIT
WINDROWER CODES appears.
9. Press right arrow (A) to select YES. Press SELECT (C).
• VIEW ENGINE CODES will appear on the upper line.
• NO/YES will appear on the lower line.
10. Press right arrow (C) to select YES. Press SELECT (D).
11. Press left arrow (B) or right arrow (C) to cycle through the
last ten recorded engine error codes until EXIT ENGINE
CODES appears.
12. Press right arrow (C) to select YES. Press SELECT (D).
13. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next diagnostic option.

7.8.2 Enabling or Disabling Header Sensors

Each header sensor can be enabled or disabled using the windrower's cab display module (CDM).
NOTE:
• The header must be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
• Disabled sensors generate the flashing message SENSOR on the CDM when the header is operating. This message
indicates that the output from this sensor has been disabled.
262320
CAB DISPLAY MODULE
B
Figure 7.103: Windrower Codes
A
B
Figure 7.104: Engine Codes
251
VIEW WINDRWR CODES?
CXXX
MXXX
NO/YES
VIEW ENGINE CODES?
CXXX
MXXX
NO/YES
C C
A
D C
C
Revision A