Activating Swath Compressor - MacDon M155 Unloading And Assembly Instructions

4. Press SELECT (D) until HDR CUT WIDTH? #### is displayed
on the upper line.
• Previous cutting width is displayed on the lower line.
5. Press left arrow (B) or right arrow (C) to change the header
cut width. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.

7.3.12 Activating Swath Compressor

An optional swath compressor is available. Before the swath compressor can be used, it must be activated in the cab
display module (CDM).
NOTE:
• CDM5 (version 512 or later) and WCM2 (version 237 or later), or WCM3 (version 116 or later), are required to operate
the swath compressor.
• The Double Windrow Attachment (DWA) system must be disabled in the CDM when setting up the swath compressor.
• Users can activate and set up the swath compressor via in-cab controls without a header attached to the windrower.
To activate the swath compressor, do the following:
DANGER
Check to be sure all bystanders have cleared the area.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? appears on the upper line.
• NO/YES appears on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? appears on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.40: Header Cut Width
MXXX
A
Figure 7.41: Programming Buttons
222
HDR CUT WIDTH? 0101
CXXX
20.5 FEET
B
WINDROWER SETUP?
CXXX
NO/YES
D
C
C
B
Revision A