Setting The Header Cut Width - MacDon R216 Unloading And Assembly Instructions

5.2.4 Setting the Header Cut Width

The header sends an electrical signal to the windrower to produce a header ID. However, the cut width will always default
to the smallest header size available for each header type. Once you connect the R216 Rotary Disc Header to the M205 SP
Windrower, the cab display module (CDM) will automatically detect the correct header ID ( DISC and 0001 ) but you
need to change the default size of 13.0 FT to a cut width that will optimize your acre count.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
Set the header cut width to less than the effective cutting width (16 ft. 2 in.) of the header in order to accurately
measure the number of acres cut.
1. Turn the ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
WINDROWER SETUP? is displayed on the upper line.
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
SET KNIFE SPEED? is displayed.
4. Press SELECT (D) until HDR CUT WIDTH? 0001 is displayed
on the upper line.
The previous cutting width is displayed on the
lower line.
5. Press left (B) or right (C) arrows to change the header cut
width. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
215974
ATTACHING ROTARY DISC HEADER TO WINDROWER
86
WINDROWER SETUP?
C###
X###
A
Figure 5.106: M205 SP Windrower CDM Programming
Buttons
HDR CUT WIDTH? 0001
C###
X###
15.5 FEET
A
B
Figure 5.107: M205 SP Windrower Header Cut Width
NO/YES
C
B
D
C
Revision A