Activating Rotary Disc Speed Control Lockout - MacDon M155 Unloading And Assembly Instructions

7.4.7 Activating Rotary Disc Speed Control Lockout

Activating the rotary disc speed control lockout in the windrower's cab display module (CDM) prevents unauthorized
Operators from changing the disc speed of the attached rotary disc header.
NOTE:
• This procedure applies to windrowers with attached rotary disc headers only.
• The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
To activate the rotary disc speed control lockout:
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (B) until SET CONTROL LOCKS? appears on the
upper line.
• NO/YES will appear on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
262320
CAB DISPLAY MODULE
A
Figure 7.73: CDM Programming Buttons
Figure 7.74: Control Locks
237
WINDROWER SETUP?
CXXX
MXXX
NO/YES
CXXX SET CONTROL LOCKS?
MXXX
NO/YES
C
B
B
A
Revision A