Changing Windrower Display Units - MacDon M155 Unloading And Assembly Instructions

4. Press right arrow (C) to select YES. Press SELECT (D).
• DISPLAY LANGUAGE? will appear on the upper line.
• Default language will appear on the lower line.
5. Press left arrow (B) or right arrow (C) to select your
preferred language.
NOTE:
The available languages are English, Russian, and Spanish.
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next CAB DISPLAY SETUP?
action.

7.2.2 Changing Windrower Display Units

The cab display module (CDM) can be configured so that units of measurement are displayed in metric or in standard
(imperial) format.
1. Turn the ignition key to the RUN position, or start the
engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press SELECT (B) until CAB DISPLAY SETUP? is displayed on
the upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.4: Language Display
MXXX
A
Figure 7.5: CDM Programming Buttons
MXXX
Figure 7.6: Cab Display Setup
206
DISPLAY LANGUAGE?
CXXX
ENGLISH
B
WINDROWER SETUP?
CXXX
NO/YES
CAB DISPLAY SETUP?
CXXX
NO/YES
D
C
B
B
A
Revision A