Activating Knife Speed Control Lockout - MacDon M155 Unloading And Assembly Instructions

4. Press SELECT (B) until SET CONTROL LOCKS? appears on the
upper line.
• NO/YES will appear on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
6. Press SELECT (D) until AUGER SPEED appears on the
upper line.
• ENABLED/LOCKED will appear on the lower line.
7. Press left arrow (B) to enable the AUGER SPEED control
switch.
Press right arrow (C) to lock the AUGER SPEED control
switch.
8. Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.4.6 Activating Knife Speed Control Lockout

Activating the header knife speed control lockout in the windrower's cab display module (CDM) prevents unauthorized
Operators from changing the knife speed of the attached header.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
262320
CAB DISPLAY MODULE
Figure 7.68: Control Locks
A
B
Figure 7.69: Auger Control Lock
235
CXXX SET CONTROL LOCKS?
MXXX
NO/YES
CXXX AUGER SPEED
MXXX
ENABLED/LOCKED
B
A
D
C
Revision A