MacDon M155 Unloading And Assembly Instructions page 83

6. Tighten both clamps (A) just enough to permit stack (B)
to move.
7. Close the hood slowly so stack (A) enters hole (B) in the
hood. Adjust the position of the stack as required to clear
the hole in the hood.
8. Raise the hood.
9. Tighten clamps (A).
10. Reposition shroud (B) and tighten the wing nut.
262320
ASSEMBLING WINDROWER
Figure 3.63: Exhaust Stack under Hood
Figure 3.64: Exhaust Stack Installed
Figure 3.65: Exhaust Stack under Hood
67
B
A
A
B
B
A
Revision A