Testing Draper Drive Circuit Activate Function Using Cab Display Module - MacDon M155 Unloading And Assembly Instructions

5. Press SELECT (B) until ACTIVATE FUNCTIONS? appears on
the upper line.
• NO/YES will appear on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
• ACTIVATE HEADER HT will appear on the upper line.
7. Press SELECT (E) until KNIFE DRIVE SPD XXXX appears on
the upper line.
8. Press and hold HAZARD (C) button.
• Press left arrow (B) to decrease the knife speed.
• Press right arrow (D) to increase the knife speed.
IMPORTANT:
Do NOT overspeed the knife drive.
IMPORTANT:
Ensure that the knife drive is working properly.
9. Release HAZARD button (C). The knife will stop.
10. Press PROGRAM (A) to exit programming mode or press
SELECT (E) to proceed to the next header function option.

7.9.5 Testing Draper Drive Circuit Activate Function Using Cab Display Module

The cab display module (CDM) can be used to test the draper drive circuit, rather than using the controls on the operator's
station.
IMPORTANT:
Do NOT overspeed the draper drive. Overspeeding can lead to vibration, belt failures, or other overspeeding-related
problems.
NOTE:
• A draper header must be attached to windrower to perform this procedure.
• The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
262320
CAB DISPLAY MODULE
MXXX
Figure 7.129: Functions
MXXX
A
B
Figure 7.130: Knife Drive
262
ACTIVATE FUNCTIONS?
CXXX
NO/YES
CXXX KNIFE DRV SPD XXXX
D 0 P 0
C
B
A
- +
D E
D
Revision A