MacDon M155 Unloading And Assembly Instructions page 265

6. Press and hold button (B) to raise the swath compressor.
• CALIBRATING SWATH will appear on the upper line.
• The messages FORM UP and HOLD (this message will
flash) will appear on the lower line and will remain until
the system has received a signal from the swath
compressor indicating that it has risen fully.
• SWATH FORM UP DONE (accompanied by a buzzer
tone) will appear on the lower line when the process is
complete.
• SWATH SENSOR CAL will appear on the upper line.
• PRESS SWATH DOWN will appear on the lower line.
7. Press and hold button (A) to lower the swath compressor.
• CALIBRATING SWATH will appear on the upper line.
• The messages FORM DOWN and HOLD (this message
will flash) will appear on the lower line.
• SWATH FORM COMPLETE will appear for two seconds
on the lower line (accompanied by a buzzer tone) when
the calibration procedure is complete.
8. Press PROGRAM to exit programming mode.
262320
CAB DISPLAY MODULE
Figure 7.98: Swath Compressor Controls
A - Lower Swath Compressor
B - Raise Swath Compressor
Figure 7.99: Swath Compressor Sensor Calibration
Figure 7.100: Swath Compressor Controls
A - Lower Swath Compressor
B - Raise Swath Compressor
249
SWATH SENSOR CAL
C###
M###
PRESS SWATH DOWN
A
B
A
B
Revision A