MacDon M155 Unloading And Assembly Instructions page 149

16. Remove the lynch pin from clevis pin (A) in stand (B).
17. Hold stand (B) and remove pin (A).
18. Move stand (B) to the storage position by inverting it and
relocating it onto the bracket as shown. Reinsert clevis
pin (A) and secure it with the lynch pin.
19. Remove the clevis pin from storage position (B) in the
linkage and insert it into hole (A) to engage the float
springs. Secure it with the hairpin. Repeat this step on the
opposite float linkage.
20. Disengage the safety prop by turning lever (A) downwards
until the lever locks into the vertical position.
21. Repeat the previous step to disengage the other
safety prop.
262320
ATTACHING HEADERS
Figure 6.27: Header Stand
Figure 6.28: Header Float Linkage
Figure 6.29: Safety Prop Lever
133
A
A
A
B
B
Revision A