Activating Reel Speed Control Lockout - MacDon M155 Unloading And Assembly Instructions

6. Press SELECT (D) until DISK SPEED appears on the
upper line.
• ENABLED/LOCKED will appear on the lower line.
7. Press left arrow (B) to enable the DISK SPEED control
switch, or press right arrow (C) to lock the DISK SPEED
control switch.
8. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.4.8 Activating Reel Speed Control Lockout

Activating the reel speed control lockout in the windrower's cab display module (CDM) prevents unauthorized Operators
from changing the reel speed of the attached rotary disc header.
NOTE:
This procedure applies to windrowers with attached draper headers only.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
1. Turn the ignition key to the RUN position, or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
B
Figure 7.75: Disc Speed Control Lock
MXXX
A
Figure 7.76: CDM Programming Buttons
238
CXXX DISK SPEED
ENABLED/LOCKED
WINDROWER SETUP?
CXXX
NO/YES
D
C
C
B
Revision A