Cab Display Options; Setting Cab Display Language - MacDon M155 Unloading And Assembly Instructions

7.2 Cab Display Options

The cab display module's (CDM) display settings, including the units of measurement, buzzer volume, and lighting options,
can be changed by accessing the CDM's CAB DISPLAY SETUP menu.
NOTE:
The following procedures are current for CDM software version C512 and windrower control module (WCM) M236. The
WCM is supplied with the latest released version of the operating software already installed. Any subsequent updates will
be made available on the MacDon Dealer Portal (https://portal.macdon.com).
NOTE:
The menus in the CDM in your windrower may differ from those depicted in the illustrations in this manual if your CDM or
WCM have different software versions installed. In addition, not all features are available on every machine.

7.2.1 Setting Cab Display Language

The cab display module's (CDM) language settings can be changed by accessing the CDM's DISPLAY LANGUAGE sub-menu
in the CAB DISPLAY SETUP menu.
1. Turn the ignition key to the RUN position, or start the
engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
cab display module (CDM) to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press SELECT (A) until CAB DISPLAY SETUP? appears on the
upper line.
• NO/YES will appear on the lower line.
262320
CAB DISPLAY MODULE
A
Figure 7.2: Windrower Setup Display
Figure 7.3: Cab Setup Display
205
WINDROWER SETUP?
CXXX
MXXX
NO/YES
CAB DISPLAY SETUP?
CXXX
MXXX
NO/YES
B
A
Revision A