Activating Hydraulic Purge Using Cab Display Module - MacDon M155 Unloading And Assembly Instructions

7.9.10 Activating Hydraulic Purge Using Cab Display Module

The hydraulic purge removes air from the hydraulic pump system after it has been repaired or changed. A purge can be
initiated by accessing the WINDROWER SETUP menu in the windrower's cab display module (CDM).
NOTE:
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
cab display module (CDM) to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
3. Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
262320
CAB DISPLAY MODULE
A
Figure 7.151: CDM Programming Buttons
Figure 7.152: Diagnostic Functions
271
WINDROWER SETUP?
CXXX
MXXX
NO/YES
DIAGNOSTIC MODE?
CXXX
MXXX
NO/YES
B
B
A
Revision A