MacDon M155 Unloading And Assembly Instructions page 194

2. If the windrower was previously attached to an R Series
Rotary Disc Header, make sure to remove the forming
shield (not shown), including forming shield support
brackets (A) and hardware (B) from both legs. You can store
the brackets and hardware in the windrower tool box.
• For more information about the forming shield, refer to
the header operator's manual.
3. Before beginning this procedure, make sure both draper
header supports (A) are either:
• (B) Installed on the windrower lift linkages, or
• (C) Installed in the header legs
For instructions on installing the header supports onto the
windrower, refer to 6.3.1 Attaching Draper Header
Supports, page 161. Header supports are typically left
installed in the header legs when the header is detached
from the windrower.
262320
ATTACHING HEADERS
Figure 6.133: Forming Shield bracket – R Series
B
C
Figure 6.134: Header Supports Installed
178
A
A
A
B B
Revision A