Activating Hydraulic Center-Link - MacDon M155 Unloading And Assembly Instructions

7. Press right arrow (C) to select YES. Press SELECT (D).
• DWA AUTO UP/DOWN? appears on the upper line.
• NO/YES appears on the lower line.
NOTE:
If YES is selected, the DWA Auto-Up function will be
activated by the GSL reel fore-aft button.
8. Press right arrow (C) to select YES. Press SELECT (D).
9. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next windrower setup option.

7.3.9 Activating Hydraulic Center-Link

Once the hydraulic center-link has been installed on the windrower, it must be activated in the cab display module's (CDM)
WINDROWER SETUP menu.
To activate the hydraulic center-link, follow these steps:
NOTE:
This procedure is provided on the assumption that the Hydraulic Center-Link kit (B4650) has been installed.
1. Turn the ignition key to RUN or start the engine.
2. Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? appears on the upper line.
• NO/YES appears on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
262320
CAB DISPLAY MODULE
A
B
Figure 7.34: DWA Programming Display
A
Figure 7.35: CDM Programming Buttons
219
CXXX DWA AUTO UP / DOWN?
MXXX NO/YES
WINDROWER SETUP?
CXXX
MXXX
NO/YES
D
C
C
B
Revision A