Activating Hay Conditioner - MacDon M155 Unloading And Assembly Instructions

11. Press PROGRAM (A) to exit programming mode or press
SELECT (B) to proceed to the next windrower setup option.

7.3.13 Activating Hay Conditioner

An optional hay conditioner is available for installation on the header. To use the hay conditioner, it must be activated in
the windrower's cab display module (CDM). The HAY CONDITIONER sub-menu can be accessed from the CDM's
WINDROWER SETUP menu.
NOTE:
• This procedure applies to windrowers with an attached draper header only.
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.44: CDM Programming Buttons
MXXX
A
Figure 7.45: Cab Display Module
224
WINDROWER SETUP?
CXXX
NO/YES
WINDROWER SETUP?
CXXX
NO/YES
B
C
B
Revision A