MacDon M155 Unloading And Assembly Instructions page 94

10. Attach the stud (supplied with the radio) to the center rear
of the radio.
11. Attach support (B) to the stud on the back of the radio with
nut (A) and the lock washer supplied with the support.
NOTE:
The support can be attached to the radio in multiple
locations to allow for proper radio mounting.
12. Install the radio panel using the original screws.
13. Adjust bracket (A) (if necessary) by loosening nuts (B) to
allow the radio to slide into the opening and securely
capture support (C).
14. Retrieve the antenna from inside the cab and remove the
protective cover from the base.
15. Remove protective cover (A) from the antenna mount on
the cab roof and thread the antenna onto the base until it
is hand-tight.
NOTE:
Store the protective cover in the cab and reinstall it to
protect the antenna mount in the event that the antenna
needs to be removed.
262320
ASSEMBLING WINDROWER
Figure 3.87: Radio and Support
Figure 3.88: Radio and Support
Figure 3.89: Antenna Mount on Cab Roof
78
A
B
C
A
A
B
Revision A