Displaying Active Cab Display Lockouts - MacDon M155 Unloading And Assembly Instructions

7.5 Displaying Active Cab Display Lockouts

The Operator can generate a list of all windrower features which have been locked out by accessing the cab display
module's (CDM) VIEW CONTROL LOCKS sub-menu.
NOTE:
To display the header tilt control lock, the Hydraulic Center-Link kit (MD #B4650) must be installed.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (B) until VIEW CONTROL LOCKS? appears on
the upper line.
• NO/YES will appear on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
HEADER TILT will appear on the upper line.
• The control switch status will appear on the lower line.
The hours displayed indicate when a switch was
enabled or locked.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.79: CDM Programming Buttons
MXXX
Figure 7.80: Control Locks
240
WINDROWER SETUP?
CXXX
NO/YES
VIEW CONTROL LOCKS
CXXX
NO/YES
C
B
B
A
Revision A