MacDon M155 Unloading And Assembly Instructions page 279

1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
3. Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
5. Press SELECT (B) until ACTIVATE FUNCTIONS? appears on
the upper line.
• NO/YES will appear on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
• ACTIVATE HEADER HT will appear on the upper line.
262320
CAB DISPLAY MODULE
A
Figure 7.131: CDM Programming Buttons
Figure 7.132: Diagnostic Functions
Figure 7.133: Functions
263
WINDROWER SETUP?
CXXX
MXXX
NO/YES
DIAGNOSTIC MODE?
CXXX
MXXX
NO/YES
ACTIVATE FUNCTIONS?
CXXX
MXXX
NO/YES
B
B
A
B
A
Revision A