Activating Auger Speed Control Lockout - MacDon M155 Unloading And Assembly Instructions

6. Press SELECT (D) until DRAPER SPEED appears on the
upper line.
• ENABLED/LOCKED will appear on the lower line.
7. Press left arrow (B) to enable the DRAPER SPEED control
switch, or press right arrow (C) to lock the DRAPER SPEED
control switch.
8. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.4.5 Activating Auger Speed Control Lockout

Activating the auger speed control lockout in the windrower's cab display module (CDM) prevents unauthorized Operators
from changing the auger speed of the attached header.
NOTE:
• This procedure applies to windrowers with attached A40D Auger Headers only.
• An auger header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the
header profile based on the type of attached header.
To activate the auger speed control lockout:
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
B
Figure 7.66: Draper Control Lock
MXXX
A
Figure 7.67: CDM Programming Buttons
234
CXXX DRAPER SPEED
ENABLED/LOCKED
WINDROWER SETUP?
CXXX
NO/YES
D
C
C
B
Revision A