Setting The Header Index Mode - MacDon M155E4 Unloading And Assembly Instructions

5.3.5 Setting the Header Index Mode

Header Index feature is not applicable to rotary disc headers. Index mode links reel and draper speed to ground
speed.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
4. Press SELECT (D) until HEADER INDEX MODE? is
displayed on the upper line.
•
REEL & CONVEYOR or REEL ONLY is displayed
on the lower line.
5. Press left (B) or right (C) arrows to set HEADER INDEX
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
214738
CAB DISPLAY MODULE (CDM)
Figure 5.25: CDM Programming Buttons
Figure 5.26: Header Index Mode
63
Revision A