Setting Hydraulic Overload Pressure - MacDon M155 Unloading And Assembly Instructions

7.3.4 Setting Hydraulic Overload Pressure

The hydraulic overload pressure setting determines the reported hydraulic pressure at which an overload pressure warning
will appear on the cab display module (CDM). This setting can be changed by accessing the OVERLOAD PRESSURE sub-
menu in the WINDROWER SETUP menu.
NOTE:
• This procedure requires the installation of the optional hydraulic pressure sensor kit (MD #B5574). For the appropriate
overload pressure value, refer to the pressure sensor installation instructions supplied with the kit.
• To enable the hydraulic pressure sensor, refer to
To set the hydraulic overload pressure setting:
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
cab display module (CDM) to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear.
4. Press SELECT (D) until OVERLOAD PRESSURE? appears on
the upper line.
• The current overload pressure will appear on lower line.
NOTE:
The range of possible pressure settings is 17,237–
34,474 kPa (2500–5000 psi).
5. Press left arrow (B) or right arrow (C) to configure the
hydraulic overload pressure setting. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
262320
CAB DISPLAY MODULE
7.8.2 Enabling or Disabling Header Sensors, page
MXXX
A
Figure 7.23: CDM Programming Buttons
MXXX
A
Figure 7.24: Hydraulic Overload Pressure
214
251.
WINDROWER SETUP?
CXXX
NO/YES
OVERLOAD PRESSURE?
CXXX
4000 PSI
B
C
B
D
C
Revision A