MacDon M155 Unloading And Assembly Instructions page 234

To configure the DWA, follow these steps:
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
cab display module (CDM) to enter programming mode.
• WINDROWER SETUP? appears on the upper line.
• NO/YES appears on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? appears on the upper line.
4. Press SELECT (B) until DWA INSTALLED? appears on the
upper line.
• NO/YES appears on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
6. SWAP DWA CONTROLS? appears on the upper line.
• NO/YES appears on the lower line.
NOTE:
This step is necessary to enable the ground speed lever's
(GSL) reel fore-aft buttons to control the DWA.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.31: CDM Programming Buttons
MXXX
Figure 7.32: DWA Programming Display
MXXX
Figure 7.33: DWA Programming Display
218
WINDROWER SETUP?
CXXX
NO/YES
DWA INSTALLED?
CXXX
NO/YES
SWAP DWA CONTROLS?
CXXX
NO/YES
C
B
B
A
Revision A