Setting Header Cut Width - MacDon M155 Unloading And Assembly Instructions

4. Press SELECT (C) until DISC BLK INSTALLED? appears on the
upper line.
• NO/YES appears on the lower line.
5. Press right arrow (B) to select YES. Press SELECT (C).
NOTE:
When the disc drive kit (MD #B4657) is installed on the
windrower, this setting must be YES even if a rotary header
is not attached to the windrower.
6. Press PROGRAM (A) to exit programming mode, or press
SELECT (C) to proceed to the next WINDROWER SETUP
option.

7.3.11 Setting Header Cut Width

When a header is attached to the windrower, the windrower's computer automatically detects the type of header.
However, the windrower is unable to determine the exact size of the header attached, only its type, and therefore defaults
to the smallest available cut width for a given model. For example, A Series Auger Headers come in 4.3, 4.9, and 5.5 m (14,
16, and 18 ft.) sizes; if a 4.9 m (16 ft.) header is attached to the windrower, the windrower's computer will set the cut
width to 4.3 m (14 ft.). The cut width setting must be manually adjusted in the cab display module (CDM).
NOTE:
• The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
• The header cut width setting corresponds to the actual cutting width of the header, not the total width of the header.
To set the header cut width:
1. Turn the ignition key to RUN or start the engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
• WINDROWER SETUP? is displayed on the upper line.
• NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
262320
CAB DISPLAY MODULE
A
Figure 7.38: Rotary Disc Hydraulics
A
Figure 7.39: CDM Programming Buttons
221
DISC BLK INSTALLED?
CXXX
MXXX
NO/YES
WINDROWER SETUP?
CXXX
MXXX
NO/YES
C
B
C
B
Revision A