Adjusting Cab Display Backlighting - MacDon M155 Unloading And Assembly Instructions

5. Press SELECT (D) until BUZZER VOLUME appears on the
upper line.
• The current setting will appear on the lower line.
6. Press left (B) or right (C) arrows to adjust the buzzer volume
to the preferred level.
7. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next CAB DISPLAY SETUP?
option.

7.2.4 Adjusting Cab Display Backlighting

The cab display module (CDM) is equipped with a backlight, which makes it easier to read the display in low-light
situations. The degree of backlighting can be changed by accessing the BACKLIGHTING sub-menu in the CAB DISPLAY
SETUP menu.
1. Turn the ignition key to the RUN position, or start the
engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
cab display module (CDM) to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press SELECT (B) until CAB DISPLAY SETUP? appears on the
upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
• DISPLAY LANGUAGE? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.10: Buzzer Volume
MXXX
A
Figure 7.11: CDM Programming Buttons
MXXX
Figure 7.12: Cab Display Setup
208
BUZZER VOLUME
CXXX
B
WINDROWER SETUP?
CXXX
NO/YES
CAB DISPLAY SETUP?
CXXX
NO/YES
D
C
B
B
A
Revision A