Activating Header Float Control Lockout - MacDon M155 Unloading And Assembly Instructions

6. Press SELECT (D) until HEADER TILT appears on the
upper line.
• ENABLED/LOCKED will appear on the lower line.
7. Press left arrow (B) to enable the use of the HEADER TILT
control switch.
Press right arrow (C) to lock the HEADER TILT control
switch.
8. Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.4.2 Activating Header Float Control Lockout

Activating the header float control lockout in the windrower's cab display module (CDM) prevents unauthorized Operators
from changing the float setting of the attached header.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
B
Figure 7.57: Header Tilt Control Lock
MXXX
A
Figure 7.58: CDM Programming Buttons
230
CXXX HEADER TILT
ENABLED/LOCKED
WINDROWER SETUP?
CXXX
NO/YES
D
C
C
B
Revision A