MacDon M155 Unloading And Assembly Instructions page 239

4. Press SELECT (B) until SWATH COMPR INSTALL? appears on
the upper line.
• NO/YES appears on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
6. Press SELECT (B) until CALIBRATE SENSORS appears on the
upper line. NO/YES appears on the lower line.
7. Press right arrow (A) to select YES. Press SELECT (B).
• TO CALIBRATE SELECT appears on the upper line.
• HEADER HEIGHT appears on the lower line.
8. Press right arrow (A) to scroll through choices until SWATH
COMPR HT appears. Press SELECT (B).
• SWATH SENSOR CAL appears on the upper line.
• SWATH UP TO START appears on the lower line.
9. Press switch (A) on the console to raise the swath
compressor.
• CALIBRATING SWATH appears on the upper line.
• The messages FORM UP and HOLD (HOLD will be
flashing) appear, and will remain on the lower line until
the system has received a signal from the fully-raised
swath compressor.
• The messages SWATH FORM UP and DONE
(accompanied by a buzzer tone ) will appear on the
lower line when the calibration procedure is complete.
• SWATH SENSOR CAL appears on the upper line.
• PRESS SWATH DOWN appears on the lower line.
10. Press switch (B) on the console to lower the swath
compressor.
• CALIBRATING SWATH appears on the upper line.
• The messages FORM DOWN and HOLD appear on the
lower line.
• SWATH FORM COMPLETE flashes for two seconds on
the lower line (accompanied by a buzzer tone) when
the calibration procedure is complete.
262320
CAB DISPLAY MODULE
Figure 7.42: Swath Compressor Controls
Figure 7.43: Swath Compressor Switch
223
CXXX SWATH COMPR INSTALL?
MXXX
NO/YES
B
A
B
A
Revision A