Testing Header Tilt Activate Function Using Cab Display Module - MacDon M155 Unloading And Assembly Instructions

7. Press SELECT (D) until ACTIVATE REEL HT appears on the
upper line.
• DOWN/UP will appear on the lower line.
8. Press and hold left arrow (B) to lower the reel. Press and
hold right arrow (C) to raise the reel. Ensure that the reel is
working properly.
9. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next ACTIVATE FUNCTION.

7.9.3 Testing Header Tilt Activate Function Using Cab Display Module

It may be necessary to use the cab display module (CDM) to change the angle of the attached header, rather than using the
header tilt controls on the ground speed lever (GSL). This procedure is used to test the functionality of this feature.
NOTE:
• The header must be attached to the windrower to perform this procedure. The CDM automatically adjusts its
programming for each header.
• This procedure requires installation of the optional Hydraulic Center-Link (MD #B4650).
• The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
262320
CAB DISPLAY MODULE
A
B
Figure 7.122: Reel Height
A
Figure 7.123: CDM Programming Buttons
259
ACTIVATE REEL HT
CXXX
MXXX
DOWN/UP
WINDROWER SETUP?
CXXX
MXXX
NO/YES
D
C
B
Revision A