Testing Reel Drive Circuit Activate Function Using Cab Display Module - MacDon M155 Unloading And Assembly Instructions

7. Press SELECT (E) until DRAPER DRV SPD XXXX appears on
the upper line.
8. Press and hold HAZARD button (C).
• Press left arrow (B) to decrease the draper speed.
• Press right arrow (D) to increase the draper speed.
IMPORTANT:
Do NOT overspeed the drapers.
NOTE:
Ensure that the draper drive is working properly.
9. Release the HAZARD (C) button. The drapers will stop.
10. Press PROGRAM (A) to exit programming mode or press
SELECT (E) to proceed to the next header function option.

7.9.6 Testing Reel Drive Circuit Activate Function Using Cab Display Module

The cab display module (CDM) can be used to test the reel drive circuit, rather than using the controls on the operator's
station.
IMPORTANT:
Do NOT overspeed the reel drive. Overspeeding can lead to vibration, belt failures, or other problems.
NOTE:
• The header must be attached to the windrower to follow this procedure.
• This procedure does not apply to windrowers with attached rotary disc headers.
• The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
262320
CAB DISPLAY MODULE
MXXX
A
B
Figure 7.134: Draper Drive
MXXX
A
Figure 7.135: CDM Programming Buttons
264
CXXX DRAPER DRV SPD XXXX
D 0 P 0
C
WINDROWER SETUP?
CXXX
NO/YES
- +
D E
D
B
Revision A