MacDon M155 Unloading And Assembly Instructions page 179

3. Before beginning this procedure, make sure both draper
header supports (A) are either:
• (B) Installed on the windrower lift linkages, or
• (C) Installed in the header legs
For instructions on installing the header supports onto the
windrower, refer to 6.3.1 Attaching Draper Header
Supports, page 161. Header supports are typically left
installed in the header legs when the header is detached
from the windrower.
4. Prepare the header as follows:
• If the header supports are installed on the windrower:
Remove ring (A) and pin (B) from the header leg.
• If the header supports are installed in the header:
Remove hair pin (C) and clevis pin (D) from the
header support.
Repeat this step on the other header leg.
262320
ATTACHING HEADERS
B
C
Figure 6.100: Header Supports Installed
Figure 6.101: Header Leg — Left Side Shown
163
A
A
A
B
D
C
Revision A