Setting The Header Index Mode; Setting The Return To Cut Mode - MacDon M155 Unloading And Assembly Instructions

4.3.5 Setting the Header Index Mode

Index mode links reel and draper speed to ground speed. This feature is not applicable to rotary disc headers.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? is displayed on the upper line.
• NO/YES is displayed on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed on the upper line.
4. Press SELECT (D) until HEADER INDEX MODE? is displayed
on the upper line.
• REEL & CONVEYOR or REEL ONLY is displayed on the
lower line.
5. Press left (B) or right (C) arrows to set HEADER INDEX
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.

4.3.6 Setting the Return to Cut Mode

Return to Cut allows the Operator to resume preferred header positions and headland presets.
NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1. Turn ignition key to RUN, or start the engine.
215015
CAB DISPLAY MODULE
A
Figure 4.25: M155 CDM Programming Buttons Shown
A
Figure 4.26: M155 Header Index Mode Shown
101
WINDROWER SETUP?
CXXX
MXXX
NO/YES
HEADER INDEX MODE?
CXXX
MXXX
REEL & CONVEYOR
B
C
B
D
C
Revision A