Troubleshooting Windrower Problems; Displaying Windrower And Engine Error Codes - MacDon M155 Unloading And Assembly Instructions

7.8 Troubleshooting Windrower Problems

The cab display module (CDM) can be used as a troubleshooting tool, since it can provide information about the status of
various sensors and display error codes.

7.8.1 Displaying Windrower and Engine Error Codes

The cab display module (CDM) stores any error codes that occur during operation.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode. Press SELECT (B).
• WINDROWER SETUP? will appear on the upper line.
3. Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
5. VIEW ERROR CODES? will appear on the upper line.
• NO/YES will appear on the lower line.
6. Press right arrow (A) to select YES. Press SELECT (B).
• VIEW WINDRWR CODES? will appear on the upper line.
• NO/YES will appear on the lower line.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.101: CDM Programming Buttons
MXXX
Figure 7.102: Diagnostic Functions
250
WINDROWER SETUP?
CXXX
NO/YES
DIAGNOSTIC MODE?
CXXX
NO/YES
B
B
A
Revision A