MacDon M155 Unloading And Assembly Instructions page 248

To activate the reel fore-aft control lockout:
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (B) until SET CONTROL LOCKS? appears on the
upper line.
• NO/YES will appear on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
6. Press SELECT (D) until REEL FORE/AFT appears on the
upper line.
• ENABLED/LOCKED will appear on the lower line.
7. Press left arrow (B) to enable the REEL FORE/AFT control
switch.
Press right arrow (C) to lock the REEL FORE/AFT control
switch.
8. Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.61: CDM Programming Buttons
MXXX
Figure 7.62: Control Locks
MXXX
A
B
Figure 7.63: Reel Fore-Aft Control Lock
232
WINDROWER SETUP?
CXXX
NO/YES
CXXX SET CONTROL LOCKS?
NO/YES
CXXX REEL FORE/AFT
ENABLED/LOCKED
C
B
B
A
D
C
Revision A