Activating Cab Display Lockouts; Activating Header Tilt Control Lockout - MacDon M155 Unloading And Assembly Instructions

7.4 Activating Cab Display Lockouts

Some header configuration settings in the windrower's cab display module (CDM) can be locked, so that Operators lacking
the proper authorization will be unable to change these settings. Use this feature to keep header settings constant when
there are multiple Operators operating the windrower.
NOTE:
FUNCTION LOCKED will appear on the CDM when a header function switch which has been locked out is pressed.

7.4.1 Activating Header Tilt Control Lockout

Activating the header tilt control lockout in the windrower's cab display module (CDM) prevents unauthorized Operators
from changing the angle of the attached header.
NOTE:
• The header MUST be attached to the windrower to perform this procedure. The CDM automatically selects the header
profile based on the type of attached header.
• This procedure requires installation of the optional Hydraulic Center-Link (MD #B4650).
To activate the header tilt control lockout:
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (B) until SET CONTROL LOCKS? appears on the
upper line.
• NO/YES will appear on the lower line.
5. Press right arrow (A) to select YES. Press SELECT (B).
262320
CAB DISPLAY MODULE
A
Figure 7.55: CDM Programming Buttons
Figure 7.56: Control Locks
229
WINDROWER SETUP?
CXXX
MXXX
NO/YES
CXXX
SET CONTROL LOCKS?
MXXX
NO/YES
C
B
B
A
Revision A