MacDon M155 Unloading And Assembly Instructions page 163

16. Install pin (B) through the header leg, engaging
the U-bracket in the lift linkage. Secure the pin with
hairpin (A).
17. Repeat the previous step on the other side of the header.
18. Raise header stand (D) to its storage position by pulling
spring pin (C) and lifting the stand into the uppermost
position. Release the spring pin.
19. Remove the clevis pin from storage position (B) in the
linkage and insert it into hole (A) to engage the float
springs. Secure it with the hairpin. Repeat this step on the
opposite float linkage.
20. Disengage the safety prop by turning lever (A) downwards
until the lever locks into the vertical position.
21. Repeat the previous step to disengage the other
safety prop.
262320
ATTACHING HEADERS
B
Figure 6.61: Header Leg
Figure 6.62: Header Float Linkage
Figure 6.63: Safety Prop Lever
147
A
C
D
A
B
A
Revision A