MacDon M155 Unloading And Assembly Instructions page 60

3. Remove tie bar (A) from between the caster wheels.
Discard tie bar (A) and the hardware that was used to
install it.
4. Remove and discard the bolts and nuts from locations (A).
5. Remove and retain the following hardware for the
installation of the walking beam starting in Step
47:
• Two 3/4 x 2 1/4 in. bolts (B)
• Two washers (C)
6. Discard supports (D).
262320
ASSEMBLING WINDROWER
Figure 3.14: Caster Wheel Shipping Assembly
11, page
Figure 3.15: Caster Supports
44
A
A A
D D
B B C
B
B C
Revision A