Testing Rotary Disc Drive Circuit Activate Function Using Cab Display Module - MacDon M155 Unloading And Assembly Instructions

7.9.7 Testing Rotary Disc Drive Circuit Activate Function Using Cab Display Module

The cab display module (CDM) can be used to test the rotary drive circuit, rather than using the controls on the operator's
station.
IMPORTANT:
Do NOT overspeed the rotary drive. Overspeeding can lead to vibration, belt failures, or other problems.
NOTE:
• A rotary disc header must be attached to windrower to follow this procedure.
• The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
3. Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
• NO/YES will appear on the lower line.
4. Press right arrow (A) to select YES. Press SELECT (B).
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.139: CDM Programming Buttons
MXXX
Figure 7.140: Diagnostic Functions
266
WINDROWER SETUP?
CXXX
NO/YES
DIAGNOSTIC MODE?
CXXX
NO/YES
B
B
A
Revision A