MacDon M155 Unloading And Assembly Instructions page 154

15. Install clevis pin (A) through the support and the foot and
secure it with the hairpin.
IMPORTANT:
Ensure clevis pin (A) is fully inserted and the hairpin is
installed behind the bracket.
16. Remove the lynch pin from clevis pin (A) in stand (B).
17. Hold stand (B) and remove pin (A).
18. Move stand (B) to the storage position by inverting it and
relocating it onto the bracket as shown. Reinsert clevis
pin (A) and secure it with the lynch pin.
19. Remove the clevis pin from storage position (B) in the
linkage and insert it into hole (A) to engage the float
springs. Secure it with the hairpin. Repeat this step on the
opposite float linkage.
262320
ATTACHING HEADERS
Figure 6.39: Header Support
Figure 6.40: Header Stand
Figure 6.41: Header Float Linkage
138
A
B
A
B
A
Revision A