MacDon M155 Unloading And Assembly Instructions page 159

2. If the windrower was previously attached to an R Series
Rotary Disc Header, make sure to remove the forming
shield (not shown), including forming shield support
brackets (A) and hardware (B) from both legs. You can store
the brackets and hardware in the windrower tool box.
• For more information about the forming shield, refer to
the header operator's manual.
3. Before beginning this procedure, ensure that both draper
header supports (A) are installed onto the windrower's lift
linkage, and that the supports are compatible with the
header. For instructions on installing the header supports
onto the windrower, refer to
Supports, page 141.
4. Remove hairpin (A) from pin (B), and remove the pin from
the header leg. Repeat this step on the other side of the
header.
262320
ATTACHING HEADERS
6.2.1 Attaching Draper Header
A
Figure 6.50: Forming Shield bracket – R Series
A
Figure 6.51: Header Supports Installed
A
B
Figure 6.52: Header Leg
143
B B
Revision A