Configuring Double Windrow Attachment Controls - MacDon M155 Unloading And Assembly Instructions

1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (D) until AUTO RAISE HEIGHT? appears on the
upper line.
• The current auto raise height setting will appear on the
lower line.
NOTE:
The auto raise height setting ranges from 4.0 (minimum) to
9.5 (maximum), and can be adjusted in increments of 0.5. A
setting of 10 disables the auto raise function.
5. Press left arrow (B) or right arrow (C) to change the auto
raise height.
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.3.8 Configuring Double Windrow Attachment Controls

An optional Double Windrow Attachment (DWA) is available. If it is installed on the windrower, it must be configured to
work with the windrower's controls. The DWA can be configured in the cab display module's (CDM) WINDROWER
SETUP menu.
NOTE:
• The DWA cannot be activated if the swath compressor is enabled.
• This procedure is also applicable to the installation of a drive manifold kit (MD #139508) onto the windrower.
262320
CAB DISPLAY MODULE
A
Figure 7.29: CDM Programming Buttons
A
B
Figure 7.30: M155 Auto Raise Height Shown
217
WINDROWER SETUP?
CXXX
MXXX
NO/YES
AUTO RAISE HEIGHT?
CXXX
MXXX
4.0
C
B
D
C
Revision A