Setting Tire Size - MacDon M155 Unloading And Assembly Instructions

4. Press SELECT (D) until HEADER REEL SPEED? appears on the
upper line.
• RPM/MPH or RPM/KPH will appear on the lower line.
5. Press left arrow (B) or right arrow (C) to select either
IMPERIAL or METRIC units. Press SELECT (D).
6. Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to the next WINDROWER SETUP
option.

7.3.15 Setting Tire Size

The windrower's tire size must be correctly configured in the cab display module (CDM) for the windrower's ground speed
to be reported accurately. This setting can be configured by accessing the SET TIRE SIZE sub-menu in the WINDROWER
SETUP menu.
1. Turn the ignition key to the RUN position or start the
engine.
2. Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
• WINDROWER SETUP? will appear on the upper line.
• NO/YES will appear on the lower line.
3. Press right arrow (B) to select YES. Press SELECT (C).
• SET KNIFE SPEED? will appear on the upper line.
4. Press SELECT (D) until SET TIRE SIZE? appears on the
upper line.
• The current tire size setting will appear on the
lower line.
NOTE:
The following tire size options are available:
• 18.4 x 26 TURF
• 18.4 x 26 BAR
• 23.1 x 26 TURF
• 600 – 65 R28
5. Press left arrow (B) or right arrow (C) and select the desired
tire size. Press SELECT (D).
262320
CAB DISPLAY MODULE
MXXX
A
Figure 7.48: Reel Speed Display
MXXX
A
Figure 7.49: CDM Programming Buttons
MXXX
A
B
Figure 7.50: Tire Size
226
HEADER REEL SPEED
CXXX
RPM/MPH
B
WINDROWER SETUP?
CXXX
NO/YES
SET TIRE SIZE?
CXXX
18.4 X 26 TURF
D
C
C
B
D
C
Revision A