ASSEMBLING WINDROWER
C B
C
D
C B
B A
Figure 3.20: Walking Beam Installation
14. Snug up two bolts (A) underneath the beam.
15. Tighten four back bolts (B) to 447 Nm (330 lbf·ft).
16. Tighten bolts (A) underneath beam to 447 Nm (330 lbf·ft).
17. Tighten nut (C) to 136 Nm (100 lbf·ft). Make sure anti-shimmer dampener (D) is parallel to the walking beam while you
tighten nut (D).
18. Repeat Step
7, page 45
to Step
17, page 48
for the left caster.
19. Retighten the bolts (that are installed in the walking beam) after 5 and 10 hours of operation.
48
262320
Revision A