Ignition Coil Servicing - BRP Evinrude E-TEC G2 Service Manual

Thoroughly clean the crankshaft and flywheel
tapers with Cleaning Solvent and let dry.
Apply a thin, even coat of Nut Lock to the inside
taper of the flywheel.
IMPORTANT:
DO NOT over apply Nut Lock on
flywheel taper. This prevents Nut Lock from mi-
grating into upper seal of crankshaft.
Align the flywheel key-way and install the fly-
wheel. Coat the threads of a new flywheel nut with
Gasket Sealing Compound. Install the nut and
tighten to a torque of 140 to 160 ft. lbs. (190 to 217
N·m).
Stator Service
Remove six allen head screws to remove stator.
1. Stator screws
To install stator, position stator on cylinder block.
Apply Nut Lock to screw threads. Install screws
and tighten in crossing pattern to a torque of 24 to
36 in. lbs. (3 to 4 N·m).

Ignition Coil Servicing

Ignition Coil Removal
Remove spark plug lead from the spark plug.
Disconnect ignition coil electrical connector.
Remove the screw and washer retaining the igni-
tion coil bracket.
49623
1
1. Screw and washer
Make note of wire routing before removing the coil
from the mounting bracket. Remove the two
screws.
1
1. Wire routing
2. Screws
Ignition Coil Installation
Installation is the reverse of removal.
009337
Tighten screws to a torque of 84 to 106 in. lb. (10
to 12 N·m). Install spark plug lead on ignition coil
and spark plug. Connect the ignition coil electrical
connector.
Electrical and Ignition
Ignition Coil Servicing
1
2
6
009369
2
007207
135