Trim Gauge Calibration; I-Trim - BRP Evinrude E-TEC G2 Service Manual

Routine Service
Adjustments
To change or clear this setting, tilt the engine to
the full down position.
Then, simultaneously press and hold for at least
three seconds, both the up and down trim buttons.
Diagnostic Software Method
Your Dealer must use Evinrude Diagnostic soft-
ware v 6.1 or higher to limit maximum tilt-up.
1. Set Tilt Limit
Check your adjustment — tilt the outboard fully
and adjust further, if necessary. Check after each
adjustment.
Repeat this procedure until the tilt limit stops the
outboard's upward travel before it contacts the
motor well.
44
1
009143

Trim Gauge Calibration

Observe the trim gauge. If needed, use Evinrude
Diagnostics software v 6.1 or higher to calibrate
the upper and lower trim range of the gauge.
1. Calibrate Trim Sender

i-Trim

Evinrude E-TEC G2 outboards are equipped with
i-Trim, an automatic trim-assist feature. By default,
this feature is disabled from the factory.
Use the Evinrude ICON-Touch or ICON CS digital
display to enable i-Trim. If the boat is not equipped
with an ICON digital display, use the Configuration
screen of Evinrude Diagnostics software v 6.1 or
higher to enable trim assist.
1. Trim Assist
To activate the i-Trim:
•
the key switch must be in the ON position
1
009237
1
009237