Flywheel And Stator Servicing - BRP Evinrude E-TEC G2 Service Manual

Test Procedure
Make sure red and black wires are connected to
12 V battery power supply.
Set voltmeter to 12 VDC scale. Connect test leads
to terminals "A" and "B" of TNT motor connector.
Use a wire jumper to alternately connect B+ to ter-
minals "1" and "2" of tilt and trim switch connector.
The meter must indicate battery voltage (12 V)
with B+ connected to either terminal.
Tilt and Trim Module Diagram
1. Green/white wire
2. Blue/white wire
3. B+, red wire
4. B–, black wire
5. TNT motor connector
6. TNT switch connector
4 3
1
2
6
5
002063

Flywheel and Stator Servicing

Flywheel and Stator Ser-
vicing
NOTICE
Perform the timing verification procedure
after flywheel replacement.
Refer to Timing Adjustments on p. 136.
IMPORTANT:
Weak
cause low alternator output and affect outboard
performance.
An accurate test of alternator output can help
determine the flywheel's condition. Refer to
Charging System Tests on p. 126.
Flywheel Removal
WARNING
To prevent accidental starting while servic-
ing, disconnect battery cables at the battery.
Removal and installation requires removal of the
engine covers and frames.
•
See Cover Removal on p. 60.
•
See Frame Removal on p. 64.
•
See Center Frame Removal on p. 67.
Use a #2 Posi-Drive screwdriver to remove the six
screws from the air duct cover. Then remove the
air duct cover.
Electrical and Ignition
flywheel magnets can
009333
133
6