BRP Evinrude E-TEC G2 Service Manual page 93

Tests
The Tests screen displays both static and dynamic
tests. The appropriate buttons are active depend-
ing on whether the outboard is running or not run-
ning.
Static Tests
Static Tests allow diagnostic testing of system
components while the outboard is NOT running.
Tests Screen (Static Mode)
Ignition Test
Use the diagnostics software to test each ignition
circuit. Refer to Ignition System Static Test on
p. 105.
Injector Test
Use the diagnostics software to test each fuel
injector circuit. Refer to Fuel Injector Static Test
on p. 106.
Oil Pumps
Use the diagnostics software to test the oil pump
circuits. Refer to Oiling System Tests on p. 198.
Fuel Pumps
Use the diagnostics software to test the fuel lift
pump and fuel circulation pump circuits. Refer to
Fuel Pump Static Test on p. 105.
Dynamic Tests
Dynamic tests are performed with the outboard
running.
Tests Screen (Dynamic Mode)
Ignition Test
This test momentarily disables the ignition and
fuel injection circuits to one cylinder. By dropping
one cylinder, RPM and running quality changes
can be observed. Refer to Dynamic Tests on
p. 108.
009225
Injector Test
This test momentarily disables one fuel injector
circuit. By dropping one cylinder, RPM and run-
ning quality changes can be observed. Refer to
Dynamic Tests on p. 108.
Prime Oil
This test is used to cycle the oil injection pump for
priming the oiling system. Perform this test with
outboard running to activate oil pump.
Engine and Control Systems
Diagnostic Software Functions
4
009124
93