BRP Evinrude E-TEC G2 Service Manual page 142

Electrical and Ignition
Connector Servicing
Terminal Removal
Open lock mechanism and remove terminal from
connector housing.
2
1
1. Latch
2. Lock mechanism
Terminal Installation
Push terminal through seal until it is seated in con-
nector housing. Close lock mechanism.
1. Terminal
P T S
OWER IMER ERIES
The J2 and J4 connectors of the EMM are AMP
Power Timer Series connectors.
Disconnect
Use a screw driver to open latch. Pull connector
from plug.
142
2 2
1
002453
1
002454
Connect
Push connector until seated in plug. Close latch
completely.
1. J2 connector
2. Latch (closed)
Terminal Removal
Use Terminal Release Tool, P/N 351413, to
release BOTH locking mechanisms of connector.
Pull terminal from housing.
1. Locking mechanism(s)
1. Terminal release tool
1
2
002120
1
1
002455
002313