BRP Evinrude E-TEC G2 Service Manual page 348

Stern and Swivel
Stern & Swivel Bracket
Place the locking washer over the steering shaft
with the locating tab in the hole at the rear of the
steering arm.
1. Locating tab
Use Spanner Socket, P/N 359224, to install the
spanner nut. Tighten the spanner nut to a torque
of 59 to 70 Ft.lbs. (80 to 94 N·m)
1. Spanner nut
Install the cover and o-ring.
2
1. Cover
2. O-ring
348
Install the three screws in the steering arm cover.
Tighten screws to a torque of 79 to 96 In.lbs.
(9 to 10 N·m).
1
009654 1. Screws
Install the engine on the stern and swivel bracket
assembly. Refer to Installation on p. 337.
Lower Bracket Removal
Use Spanner Wrench, P/N 912084, to remove the
lower cover and o-ring.
1
009646
1. Lower cover and o-ring
1
Use a bent-jaw retaining ring pliers to remove the
retaining ring.
009645
1. Retaining ring
1
009644
1
009650
1
009651